What the example shows
The photo shows how a small mark repeats across cavities. The design question is the relief depth and wall support that keep lettering legible on the finished piece while still releasing cleanly.
- Design decisions
- Agree the logo as raised or recessed, the minimum stroke width and the relief depth at finished size. Review isolated islands and narrow gaps for support, and the draft that lets the piece release without tearing detail.
- What to send for a similar mold
- Send vector artwork if available, finished piece size, the casting material and order quantity. Mark the smallest stroke and any fine gap that must survive release.
- Prototype checks to agree
- Cast with the intended material and check legibility, island retention and release. Review a sampled piece at actual size. Agree any relief or gap change before repeating the approved logo mold.